Q55. Which of the following is used to measure the length of a 4-pair cable?

Q56. What is the minimum number of consolidation points that should serve an open office furniture cluster?

Q57. Which topology uses a linear configuration that places all network devices on one length of cable?

Q58. Which of the following makes the biggest impression on a customer when you are communicating via email?

Q59. What is the recommended thickness for plywood that will be mounted on the walls of a telecommunications room?

Q60. Which of the following components is used to bond the electrical system’s grounding electrode system to the PBB?

Q61. What type of connector is used with ribbon cable?

Q62. Which of the following are typically used to support cables between a cable tray and work area outlets?

Q63. How much sheath of the cable needs to be removed in order to properly terminate an 8P8C?

Q64. Which of the following topologies is the recommended topology for distribution systems in campus environments?

Q65. Which of the following markings is used for non-conductive optical fiber general-purpose cables?

Q66. Which of the following interconnects the PBB to the SBB?

Q67. Electrical power (P) is measured in ___________?

Q68. Which of the following fire ratings refers to the time period that the unexposed surface of a firestop assembly does not exceed 180 degrees C (325 degrees F) above its initial temperature?

Q69. Which type of cabling is installed between a main cross-connect (campus distributor) and an intermediate cross-connect (building distributor)?

Q70. Cavity boxes should be at least _____ away from the wall, where possible.

Q71. How much cable slack should be left in the work area after termination?

Q72. Which of the following is used to establish a 0 volt (V) reference for ac electrical power systems?

Q73. Which of the following is used to equalize potential differences between the SBB on the same floor?

Q74. Which of the following is used to connect cabinets to the nearest SBB?

Q75. Which of the following tend to cause sheath damage during cable pulling?

Q76. What is the maximum allowable horizontal cable length?

Q77. Which pair of a 100-ohm balanced twisted pair patch cable has a white-brown tip and a brown-white ring?

Q78. What is the specified performance level for Category 6 cable?

Q79. If you are working on a catwalk, you are required to wear _____?