Q47. A remote physical server is unable to communicate to the network through the available NICs, which were misconfigured. However, the server administrator is still able to configure the server remotely. Which of the following connection types is the server administrator using to access the server?

Q48. A technician is building a lab to learn storage redundancy techniques. Which of the following is the MOST cost-effective method the technician can deploy?

Q49. Which of the following is a method that is used to prevent motor vehicles from getting too close to building entrances and exits?

Q50. Network connectivity to a server was lost when it was pulled from the rack during maintenance.
Which of the following should the server administrator use to prevent this situation in the future?

Q51. An administrator has attached an old SCSI JBOD to a server to recover archival dat a. However, the array will not mount to the server. Which of the following should the administrator check FIRST?

Q52. A server administrator is configuring a new server that will hold large amounts of information. The server will need to be accessed by multiple users at the same time. Which of the following server roles will the administrator MOST likely need to install?

Q53. An administrator is configuring a host-based firewall tor a server. The server needs to allow SSH, FTP, and LDAP traffic. Which of the following ports must be configured so this traffic will be allowed? (Select THREE).

Q54. A DHCP server is configured to issue IP addresses. Client machines have successfully obtained an IP address. However, when testing, users are unable to browse the Internet. Which of the following might be the MOST likely cause?

Q55. A technician wants to limit disk usage on a server. Which of the following should the technician implement?

Q56. Which of the following can be BEST described as the amount of time a company can afford to be down during recovery from an outage?

Q57. A server administrator is swapping out the GPU card inside a server.
Which of the following actions should the administrator take FIRST?

Q58. A technician has several possible solutions to a reported server issue. Which of the following BEST represents how the technician should proceed with troubleshooting?

Q59. A server shut down after an extended power outage. When power was restored, the system failed to start. A few seconds into booting, the Num Lock, Scroll Lock, and Caps Lock LEDs flashed several times, and the system stopped. Which of the following is the MOST likely cause of the issue?

Q60. An administrator is configuring a server to communicate with a new storage array. To do so, the administrator enters the WWPN of the new array in the server’s storage configuration. Which of the following technologies is the new connection using?

Q61. A server administrator is configuring a new server that will hold large amounts of information. The server will need to be accessed by multiple users at the same time. Which of the following server roles will the administrator MOST likely need to install?

Q62. A technician needs to install a Type 1 hypervisor on a server. The server has SD card slots, a SAS controller, and a SATA controller, and it is attached to a NAS. On which of the following drive types should the technician install the hypervisor?

Q63. Which of the following will correctly map a script to a home directory for a user based on username?

Q64. Which of the following steps in the troubleshooting theory should be performed after a solution has been implemented? (Choose two.)

Q65. A storage administrator is investigating an issue with a failed hard drive. A technician replaced the drive in the storage array; however, there is still an issue with the logical volume. Which of the following best describes the NEXT step that should be completed to restore the volume?

Q66. Which of the following is an example of load balancing?