Huawei H12-811_V1.0 Exam Preparation Guide and PDF Download [Q109-Q131]

admin • December 14, 2024

Huawei H12-811_V1.0 Exam Preparation Guide and PDF Download [Q109-Q131]

Rate this post

Huawei H12-811_V1.0 Exam Preparation Guide and PDF Download

Verified & Correct H12-811_V1.0 Practice Test Reliable Source Dec 14, 2024 Updated

Huawei H12-811_V1.0 (HCIA-Datacom V1.0) certification exam is a highly recognized certification in the field of data communications. It is designed to help professionals enhance their skills and knowledge in data communication technologies and improve their career prospects. HCIA-Datacom V1.0 certification exam is suitable for network administrators, network engineers, and other IT professionals who are interested in expanding their knowledge of data communication technologies.

NEW QUESTION 109
The information shown in the figure is the port status information displayed on a switch running STP. According to this information, what is wrong in the following description? () (Single-choice question)

This switch is the root switch in the network

The priority of this switch is 0

This network may only contain this switch

This switch may be connected to 6 other switches

NEW QUESTION 110
By default, the port cost calculated by STP has a certain relationship with the port bandwidth, that is, the larger the bandwidth, the higher the cost ()

Big

Unanimous

uncertain

small

NEW QUESTION 111
The FIT AP can obtain the IP address of AC. through the DHCP Option to establish a CAPWAP tunnel. Which Option needs to be configured on the DHCP server for this? ()

Option 82

Option 10

Option 43

Option 55

NEW QUESTION 112
In the network shown in the figure below, Router A uses manual mode link aggregation, and adds G0/0/1 and G0/0/2 ports to aggregation group 1. What is wrong about the status of Router A’s aggregation port 1?

Only disable port G0/0/1 of Router B, and Eth-Trunk 1 protocol up

Turn off the G0/0/1 and G0/0/2 ports of Router B at the same time, and Eth-Trunk 1 protocol down

Turn off the G0/0/1 and G0/0/2 ports of Router B at the same time, and Eth-Trunk 1 protocol up

Only close the G0/0/2 port of Router B, and Eth-Trunk 1 protocol up

NEW QUESTION 113
A host must configure a gateway to communicate with other hosts.

True

False

NEW QUESTION 114
Regarding the control plane of the device, which of the following statements is correct? ()*

The control plane is responsible for the interaction of routing protocols between devices

The control plane provides device monitoring capabilities

The control plane is responsible for directing data forwarding

The control plane is responsible for generating IP routing table

NEW QUESTION 115
Network switch A and router A are connected by two links. The two links are aggregated in manual load sharing mode. The aggregated port number is 1, and the aggregated link needs to carry VLAN TAG100 when forwarding dat a. The switch When A uses a trunk link, which of the following configurations need to be used by switch A? ()

NEW QUESTION 116
As shown in the figure, two switches use the default parameters to run STP root primary; Switch B uses the configuration command STP priority 0. Then which port will be blocked? () (Single-choice question)

G0/0/3 of HUB

G0/0/2 of switch A

G0/0/1 of switch A

G0/0/1 of switch B

NEW QUESTION 117
The change of the Router ID of the OSPF process takes effect immediately.

True

False

NEW QUESTION 118
The configuration information of a certain port of the switch is shown in the figure, then this port carries VLAN TAG9 when sending data frames carrying which VLAN.

1, 2, 3, 4, 6,100

2,3, 100

2,3, 4,6.100

1,2,3,100

NEW QUESTION 119
On the command line interface of Huawei AR routers, the role of the Save command is to save the current system time.

TRUE

FALSE

NEW QUESTION 120
On the network shown in the following figure, assuming that SWA, SWB, and SWC retain factory defaults, which of the following ports will be selected as a designated port?

G0/0/2 on SWC

G0/0/3 on SWA

G0/0/1 on SWB

G0/0/1 on SWC

NEW QUESTION 121
What is the maximum negotiation rate supported by the IEEE802.11g standard? ()

300Mbps

150Mbps

54Kbps

1200Mbps

NEW QUESTION 122
A DHCP server is deployed in the network, but the administrator found that some hosts did not correctly obtain the address specified by the DHCP server. What are the possible reasons?

There is another DHP server in the network that works more efficiently

Some hosts cannot communicate with the DHCP server normally, and the client systems of these hosts have automatically generated addresses in the range of 169.254.0.0

The address pool of the DHCP server has all been allocated

Some hosts cannot communicate with the DHCP server normally, and the client systems of these hosts automatically generate addresses in the range of 127.254.0.0

NEW QUESTION 123
Which of the following stages is not included in the PPPoE session establishment and termination process?

Discovery phase

Session termination stage

Data forwarding stage

Session phase

NEW QUESTION 124
By default, it takes at least 30s for the port status in the STP protocol to change from Disable D. to Forwarding status. ()

True

False

NEW QUESTION 125
Which of the following descriptions about the router is wrong?

The router can realize IP packet forwarding

The router can be used as a gateway device

The router works at the network layer

The router cannot isolate the broadcast domain

NEW QUESTION 126
Which of the following statements about the S field in the MPLS packet header are correct? ()*

The s bit has only ibit in frame mode, and 2bit in cell mode

The s bit exists in every MPLS packet header

Used to mark whether there are other labels behind this label, 1 means yes, 0 means no

Used to mark whether there are other labels behind this label, 0 means yes, 1 means no

NEW QUESTION 127
The MAC address table of existing switches is shown in the figure. Which of the following statements are correct? () (Single-choice question)

The MAC address 5489-9811-0b49 is manually configured by the administrator

The MAC address 5489-989d-1d30 is manually configured by the administrator

After the switch restarts, all MAC addresses need to be relearned. The MAC address 5489-9885-18a8 is manually configured by the administrator

The MAC address 5489-9885-18a8 is manually configured by the administrator

NEW QUESTION 128
Which of the following network types are supported by OSPF?

Point-to-point (P2P)

Point-to-multipoint (P2MP)

Broadcast

NBMA

NEW QUESTION 129
AC uses CAPTAP control tunnel transmission to FIt AP management packet

True

False

NEW QUESTION 130
UDP is connectionless and must rely on () to ensure the reliability of transmission.

Internet Protocol

Transmission Control Protocol

Network layer protocol

Application layer protocol

NEW QUESTION 131
The controller is the core component of SDN. The controller is connected to the device through the southbound interface. The following is missing from the controller southbound agreement? ()

SNMP

PCEP

OpenFlow

NETCONF

Loading …

Huawei H12-811_V1.0 (HCIA-Datacom V1.0) Certification Exam is a professional certification program designed for IT professionals who specialize in data communication technologies. HCIA-Datacom V1.0 certification is offered by Huawei Technologies Co. Ltd, one of the leading technology companies in the world that offers networking and telecommunications solutions. HCIA-Datacom V1.0 certification is designed to equip IT professionals with the skills and knowledge needed to design, operate, and maintain data communication networks.

Pass Huawei H12-811_V1.0 exam Dumps 100 Pass Guarantee With Latest Demo: https://www.2pass4sure.com/HCIA-Datacom/H12-811_V1.0-actual-exam-braindumps.html