NEW QUESTION 19
A network administrator is implementing security zones for each department. Which of the following should the administrator use to accomplish this task?

NEW QUESTION 20
A network engineer receives a vendor alert regarding a vulnerability in a router CPU. Which of the following should the engineer do to resolve the issue?

NEW QUESTION 21
You have been tasked with implementing an ACL on the router that will:
1. Permit the most commonly used secure remote access technologies from the management network to all other local network segments
2. Ensure the user subnet cannot use the most commonly used remote access technologies in the Linux and Windows Server segments.
3. Prohibit any traffic that has not been specifically allowed.
INSTRUCTIONS
Use the drop-downs to complete the ACL
If at any time you would like to bring back the initial state of the simulation, please click the Reset All button.

NEW QUESTION 22
A network administrator is deploying a new switch and wants to make sure that the default priority value was set for a spanning tree. Which of the following values would the network administrator expect to see?

NEW QUESTION 23
A network administrator needs to connect two routers in a point-to-point configuration and conserve IP space. Which of the following subnets should the administrator use?

NEW QUESTION 24
A network engineer is designing a secure communication link between two sites. The entire data stream needs to remain confidential. Which of the following will achieve this goal?

NEW QUESTION 25
As part of an attack, a threat actor purposefully overflows the content-addressable memory (CAM) table on a switch. Which of the following types of attacks is this scenario an example of?

NEW QUESTION 26
A network consultant needs to decide between running an ethernet uplink or using the built-in 5GHz-to-point functionality on a WAP. Which of the following documents provides the best information to assist the consultant with this decision?

NEW QUESTION 27
A customer needs six usable IP addresses. Which of the following best meets this requirement?

NEW QUESTION 28
Which of the following is a cost-effective advantage of a split-tunnel VPN?

NEW QUESTION 29
Which of the following devices can operate in multiple layers of the OSI model?

NEW QUESTION 30
Which of the following fiber connector types is the most likely to be used on a network interface card?

NEW QUESTION 31
A network administrator is configuring a new switch and wants to ensure that only assigned devices can connect to the switch. Which of the following should the administrator do?

NEW QUESTION 32
A network technician replaced an access layer switch and needs to reconfigure it to allow the connected devices to connect to the correct networks.
INSTRUCTIONS
Click on the appropriate port(s) on Switch 1 and Switch 3 to verify or reconfigure the correct settings:
Ensure each device accesses only its
correctly associated network.
Disable all unused switchports.
. Require fault-tolerant connections
between the switches.
. Only make necessary changes to
complete the above requirements.

NEW QUESTION 33
Which of the following connectors provides console access to a switch?

NEW QUESTION 34
A network administrator wants to configure a backup route in case the primary route fails. A dynamic routing protocol is not installed on the router. Which of the following routing features should the administrator choose to accomplish this task?

NEW QUESTION 35
SIMULATION
You have been tasked with setting up a wireless network in an office. The network will consist of 3 Access Points and a single switch. The network must meet the following parameters:
The SSIDs need to be configured as CorpNet with a key of S3cr3t!
The wireless signals should not interfere with each other
The subnet the Access Points and switch are on should only support 30 devices maximum The Access Points should be configured to only support TKIP clients at a maximum speed INSTRUCTONS Click on the wireless devices and review their information and adjust the settings of the access points to meet the given requirements.
If at any time you would like to bring back the initial state of the simulation, please click the Reset All button.

NEW QUESTION 36
Which of the following most likely requires the use of subinterfaces?