Pass Cisco 300-730 Exam with Guarantee Updated 240 Questions [Q97-Q112]

300-730 Cisco

admin • February 20, 2026

Pass Cisco 300-730 Exam with Guarantee Updated 240 Questions [Q97-Q112]

Rate this post

Pass Cisco 300-730 Exam with Guarantee Updated 240 Questions

Latest 300-730 Pass Guaranteed Exam Dumps Certification Sample Questions

NO.97 When troubleshooting FlexVPN spoke-to-spoke tunnels, what should be verified first?

NHRP redirect is enabled on the hub.

The spokes have sent a resolution request.

NHRP cache entries exist on the spoke.

NHO routes exist on the spokes.

The Next Hop Resolution Protocol (NHRP) redirect is not a strict requirement for FlexVPN spoke- to-spoke tunnels to function. NHRP redirect is typically used in DMVPN (Dynamic Multipoint Virtual Private Network) deployments to optimize the routing of traffic between spoke-to-spoke connections by allowing the hub to inform spokes about more efficient paths In a FlexVPN deployment, spokes send resolution requests to the hub for spoke-to-spoke communication. These resolution requests are typically related to Next Hop Resolution Protocol (NHRP) operations. NHRP is used in FlexVPN to dynamically map the public IP addresses of spokes to their private IP addresses, facilitating spoke-to-spoke communication without having to route all traffic through the hub.

NO.98 Which two tunnel negotiation IKEV2 debug commands are used in Cisco ASA? (Choose two.)

debug crypto ca

debug crypto ikev2 platform

debug crypto ikev2

debug crypto ikev2 error

debug crypto ikev2 protocol

On a Cisco ASA, when troubleshooting IKEv2 tunnel negotiation, the following debug commands are commonly used:
debug crypto ikev2: This is the general command to enable IKEv2 debugging, displaying logs related to tunnel negotiation, authentication, and key exchanges.
debug crypto ikev2 protocol: Provides detailed debugging for IKEv2 messages exchanged between peers, useful for diagnosing negotiation failures.

NO.99 A Cisco AnyConnect client establishes a SSL VPN connection with an ASA at the corporate office. An engineer must ensure that the client computer meets the enterprise security policy. Which feature can update the client to meet an enterprise security policy?

Endpoint Assessment

Cisco Secure Desktop

Basic Host Scan

Advanced Endpoint Assessment

Section: Remote access VPNs

NO.100 Where must an engineer configure a preshared key for a site-to-site VPN tunnel configured on a Cisco ASA?

isakmp policy

group policy

crypto map

tunnel group

NO.101 Refer to the exhibit. An engineer is diagnosing an issue that occurred after a router at a branch site was assigned a new address. Based on the debugs, what must be done to resolve this issue?

Add the remote peer’s IP address to the server’s IKEv2 keyring.

Ensure that the correct preshared keys are set on both sides.

Ensure that the UDP 500 packets between devices are not dropped.

Add the remote peer’s identity to the server’s IKEv2 profile.

NO.102 Which two statements about the Cisco ASA Clientless SSL VPN solution are true? (Choose two.)

When a client connects to the Cisco ASA WebVPN portal and tries to access HTTP resources through the URL bar, the client uses the local DNS to perform FQDN resolution.

The rewriter enable command under the global webvpn configuration enables the rewriter functionality because that feature is disabled by default.

A Cisco ASA can simultaneously allow Clientless SSL VPN sessions and AnyConnect client sessions.

When a client connects to the Cisco ASA WebVPN portal and tries to access HTTP resources through the URL bar, the ASA uses its configured DNS servers to perform FQDN resolution.

Clientless SSLVPN provides Layer 3 connectivity into the secured network.

Section: Remote access VPNs

NO.103 Which VPN technology must be used to ensure that routers are able to dynamically form connections with each other rather than sending traffic through a hub and be able to advertise routes without the use of a dynamic routing protocol?

FlexVPN

DMVPN Phase 3

DMVPN Phase 2

GETVPN

NO.104 Which VPN does VPN load balancing on the ASA support?

VTI

IPsec site-to-site tunnels

L2TP over IPsec

Cisco AnyConnect

NO.105 Drag and Drop Question
Drag and drop the actions from the left into the sequence on the right to configure Clientless SSL VPN on a Cisco ASA.

NO.106 A Cisco ASA is configured in active/standby mode. What is needed to ensure that Cisco AnyConnect users can connect after a failover event?

AnyConnect images must be uploaded to both failover ASA devices.

The vpnsession-db must be cleared manually.

Configure a backup server in the XML profile.

AnyConnect client must point to the standby IP address.

Reference:
https://www.cisco.com/c/en/us/td/docs/security/asa/asa90/configuration/guide/asa_90_cli_config/ ha_active_standby.html

NO.107

Refer to the exhibit. A customer cannot establish an IKEv2 site-to-site VPN tunnel between two Cisco ASA devices. Based on the syslog message, which action brings up the VPN tunnel?

Reduce the maximum SA limit on the local Cisco ASA.

Increase the maximum in-negotiation SA limit on the local Cisco ASA.

Remove the maximum SA limit on the remote Cisco ASA.

Correct the crypto access list on both Cisco ASA devices.

Section: Site-to-site Virtual Private Networks on Routers and Firewalls

NO.108 Refer to the exhibit.

The DMVPN tunnel is dropping randomly and no tunnel protection is configured. Which spoke configuration mitigates tunnel drops?

Option A

Option B

Option C

Option D

NO.109 A second set of traffic selectors is negotiated between two peers using IKEv2.
Which IKEv2 packet will contain details of the exchange?

IKEv2 IKE_SA_INIT

IKEv2 INFORMATIONAL

IKEv2 CREATE_CHILD_SA

IKEv2 IKE_AUTH

https://www.cisco.com/c/en/us/support/docs/security-vpn/ipsec-negotiation-ike-protocols/115936- understanding-ikev2-packet-exch-debug.html

NO.110 Refer to the exhibit.

An engineer has configured two new VPN tunnels to 172.18.1.1 and 172.19.1.1. However, communication between 10.1.0.10 and 10.1.11.10 does not function. Which action should be taken to resolve this issue?

Remove and reapply the crypto map to the interface.

Insert routes for the 10.1.9.0/24 and 10.1.10.0/24 subnets.

Modify the transform set to use transport mode.

Adjust the network objects to match the appropriate subnets.

NO.111 What is a characteristic of GETVPN?

An ACL that defines interesting traffic must be configured and applied to the crypto map.

Quick mode is used to create an IPsec SA.

The remote peer for the IPsec session is configured as part of the crypto map.

All peers have one IPsec SPI for inbound and outbound communication.

NO.112 A second set of traffic selectors is negotiated between two peers using IKEv2. Which IKEv2 packet will contain details of the exchange?

IKEv2 IKE_SA_INIT

IKEv2 INFORMATIONAL

IKEv2 CREATE_CHILD_SA

IKEv2 IKE_AUTH

Loading …

Preparation Guide of Cisco 300-730 Exam

Cisco A00-225 Prep Guide: Prep guide for the Cisco 300-730 Exam

An Analysis of the Cisco 300-730 Exam: A blog about the Cisco 300-730 exam along with preparation tips

Cisco 300-730 exam is aimed at providing the candidates with the skills and knowledge acquired the ability to launch and support a small site VPN. The 1Y0-A05 exam dumps are intended to test the candidates ability to manage Cisco ASA features and system administration. The Cisco 300-730 exam dumps are designed by experts and professionals who have rich experience in designing, developing, and providing Cisco 300-730 exam questions for the candidates to prepare for the Cisco 300-730 certification exam.

The first step in implementing secure solutions with virtual private networks (VPNs) is to learn about the four types of VPNs that exist. Each of these has a different purpose and is important to understand when preparing for the Cisco 300-730 Exam.

New 300-730 Test Materials & Valid 300-730 Test Engine: https://www.2pass4sure.com/CCNP-Security/300-730-actual-exam-braindumps.html