NEW QUESTION 30
All of these are advantages of using repair patches EXCEPT

NEW QUESTION 31
Inspectors perform tests on linings that they may not perform on exterior coatings because

NEW QUESTION 32
Inspection and Test Plans are provided to:

NEW QUESTION 33
You should bulk store coatings containing isocyanates

NEW QUESTION 34
The solvent sensitivity/solvent wipe test (ASTM D4752) is used to determine the cure of

NEW QUESTION 35
Eddy current DFT gauges are used to measure Dry Film Thickness in which of the following situations:

NEW QUESTION 36
Pre-cleaning of work pieces will NOT remove

NEW QUESTION 37
Linings are used on the interior of pipelines to

NEW QUESTION 38
Examples of non-ferrous metals include
Select All that Apply:

NEW QUESTION 39
You are NACE Level 2 Inspector working on a tank lining job where a mobile centrifugal blast unit is being used to blast the tank floor to a NACE No.1/SSPC SP 5. The Contractor has completed his final blast and has called for a hold point inspection. This is the 1 st time you have seen field based centrifugal blast cleaning. You observe what appears to be staining on the substrate however the Contractor assures you this is normal when using centrifugal blast units and what you are seeing is what is defined in the standard as an acceptable variation in appearance.
Your FIRST preferred course of action is to:

NEW QUESTION 40
When performing an adhesion test in accordance with ASTM D 3359 where the Dry Film Thickness is approximately 10 mils, the Inspector should use:

NEW QUESTION 41
The number of air turns in an enclosure can be affected by all of these EXCEPT

NEW QUESTION 42
You are the NACY Coating Inspector on a tank lining project where desiccant dehumidification is being used. Since the first shift of abrasive blasting your readings have indicated relative humidity below 40%; however on the second shift of coating application your readings are indicting 80%.
Your FIRST preferred course of action is to:

NEW QUESTION 43
You are working as the only in-house NACE Level 2 Inspector in a shop setting when an independent 3 rd party NACE Level 3 Inspector, representing the owner, presents you with a copy of a Non Conformance Report (NCR) he has written for a NACE2/SSPC SP 10 centrifugal blast which you had previously approved.
Your FIRST preferred course of action is to:

NEW QUESTION 44
You are the NACE Coating Inspector on a tank lining project and are asked to perform a high voltage holiday test after the coating applicators have completed their final repairs. After meeting all the confined space entry permit you enter the tank and notice a very strong odor of solvent.
Your first course of action should to:

NEW QUESTION 45
When NACE/SSPC WJ 1 is referenced; what type of equipment would the Inspector expect to see on the job:

NEW QUESTION 46
A failure caused by applying a coating too thinly is known as