NEW QUESTION 25
Non-Conformance Reports are designed to:

NEW QUESTION 26
Surface preparation of concrete is performed using:

NEW QUESTION 27
It is always possible to see moisture on a steel substrate:

NEW QUESTION 28
Corrosion is the reverse process of

NEW QUESTION 29
Inspection and Test Plans are provided to:

NEW QUESTION 30
When performing an adhesion test in accordance with ASTM D 3359 where the Dry Film Thickness is approximately 10 mils, the Inspector should use:

NEW QUESTION 31
Which product, is used in conjunction with other coatings such as FBE when the lines run through wetlands or a body of water?

NEW QUESTION 32
You are the NACE Level 2 Inspector on a project where overcoating of galvanized steel is being performed. The specification references SSPC SP 16 as the surface preparation method. At the pre-job meeting operations personnel make it clear that abrasive blasting will not permitted. The Owner’s representative asks you what other methods might be used.
Of the options shown below, what would be the preferred option in this situation?

NEW QUESTION 33
You are the NACE Level 2 inspector reviewing the documentation from a NACE Level 1 you notice significant documentation errors.
Your FIRST preferred course of action is to:

NEW QUESTION 34
The coating applicator has ignored a enface preparation hold point and applied coating over the surface without a sign off from you as the inspector.
Your FIRST preferred course of action is to:

NEW QUESTION 35
Examples of non-ferrous metals include
Select All that Apply:

NEW QUESTION 36
You are the NACE Level 2 Inspector with the final responsibility to prepare the final report for a very large structural steel shop project which has gone very well. It is due next week. The work has been ongoing for two years and several NACE Level 1 Inspectors have worked under your supervision throughout the project. You find you are missing one week of daily reports for the night shift from the very beginning of the project and despite your best efforts they are cannot found.
You FIRST preferred course of action is to:

NEW QUESTION 37
You are working as an inspector in a galvanizing plant for the first time.
What are some of the hazards you need to be aware of:

NEW QUESTION 38
A failure caused by applying a coating too thinly is known as

NEW QUESTION 39
When performing a hardness test on a coating which has elastic properties the inspector is likely to likely to observe:

NEW QUESTION 40
Inspectors perform tests on linings that they may not perform on exterior coatings because

NEW QUESTION 41
Inspection and Test plans are developed by referencing:

NEW QUESTION 42
The Inspectors’ goal at the Pre-Job Conference is to: